Description
Variable Coaxial Attenuator 0-20dB (75ohm)
Overview – Decibel (dB) is a logarithmicunit of measurement that expresses the magnitude of a physical quantity,usually power or intensity. This device will reduce the signal strength between0-20dB to hopefully help you achieve a better signal quality.
Compatible with;
Digital (freeview) and analogue signal signals
Satellite signals
Cable TV
Technical Details;
Frequency Range – 5-2400MHz
Attenuation – 0-20db
75ohm
Insertion Loss – Min. Attenuator
45MHz- Less than 0.5dB
1500MHz – Less than 2.5dB
2000MHz – Less than 5dB
2400MHz – Less than 8.5dB
Insertion Loss – Max. Attenuator
45MHz – 20dB
1500MHz – 19-24dB
2000MHz – 19-24dB
2400MHz- 18.5-22dB
How do I know if I need an attenuator? – If you experience break-up onsome or all of your channels whilst trying to tune in your TV, it could be thatyour signal is too strong or too weak. It will usually take trial and error towork out what the problem is. An attenuator is usually the cheapest option toestablish what the problem might be.
The example below is to guide you through a typical aerial installation,this may vary if the attenuator is not being using with an aerial, however thesame principles apply.
If you have installed an aerial and you’ve done the basics such asmaking sure it is pointing in the right direction and you are sure thatall your contacts are making a good connection then, it may also be worthlooking at houses near to you, look at their aerials, if yours looks to bepointing in a similar direction and is a similar sort of aerial, it may beworth asking them if they have any problems with reception. If their receptionis fine, it is likely that you have made a mistake somewhere when installing.If everything seems to be installed correctly and you are still gettingproblems with reception, buying this attenuator will establish whether yoursignal is too weak or too strong. When installed, if your signal qualitydeteriorates further, then your signal is too weak, if the signal goes betteryou should leave this attenuator installed and set the variable dial to thepoint that gives the best signal. One other way to reduce your signal strength(to check whether you need an attenuator) is to put your signal through anextremely long length of cable. Good quality coaxial cable loses about0.18db/metre, therefore a cable run of 40 metres would lose about 7.2db.
How to use -The attenuatorshould be positioned between your aerial (or other device) and splitter(in your loft), if you don’t have a splitter then it should bepositioned between your aerial and TV.
Peace of mind – This product hasbeen tested to CE and ROHS standards.
Reviews
There are no reviews yet.